Loading ...
Loading ...
Loading ...
Network Camera User Manual
vi
● Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery,
which may result in an explosion.
● Do not leave the battery in an extremely high temperature surrounding environment, which
may result in an explosion or the leakage of flammable liquid or gas.
● Do not subject the battery to extremely low air pressure, which may result in an explosion or
the leakage of flammable liquid or gas.
● + identifies the positive terminal(s) of equipment which is used with, or generates direct
current. - identifies the negative terminal(s) of equipment which is used with, or generates
direct current.
Fire Prevention
● No naked flame sources, such as lighted candles, should be placed on the equipment.
● The serial port of the equipment is used for debugging only.
Hot Surface Prevention
● CAUTION: Hot parts! Burned fingers when handling the parts. Wait one-half hour
after switching off before handling parts. This sticker is to indicate that the marked item can be
hot and should not be touched without taking care. For device with this sticker, this device is
intended for installation in a restricted access location, access can only be gained by service
persons or by users who have been instructed about the reasons for the restrictions applied to
the location and about any precautions that shall be taken.
Installation
● Install the equipment according to the instructions in this manual.
● To prevent injury, this equipment must be securely attached to the floor/wall in accordance
with the installation instructions.
● Never place the equipment in an unstable location. The equipment may fall, causing serious
personal injury or death.
Power Supply
● The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and
the Limited Power Source. Refer to the appropriate documentation for detailed information.
● The power source should meet limited power source or PS2 requirements according to IEC
60950-1 or IEC 62368-1 standard.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
caused by overload.
● Make sure the plug is properly connected to the power socket.
White Light Illuminator (If supported)
● Possibly hazardous optical radiation emitted from this product.
● DO NOT stare at operating light source. May be harmful to the eyes.
● Wear appropriate eye protection or DO NOT turn on the white light when you assemble, install
or maintain the camera.
Loading ...
Loading ...
Loading ...