Loading ...
Loading ...
Loading ...
25. Door preparation
Tools needed for new installation:
Pencil, Chisel, Tape Measure, Hammer, Phillips Screwdriver, 1” (25 mm) & ⅛” (3
mm) Drill Bits, 2 ⅛” (54 mm) Hole Boring Bit, Power Drill.
1. Mark door.
1.1 Mark centerline on door and jamb (see fig. 1).
1.2 Stand so door swings towards you.
2. Drill holes on door (see fig. 2, and 3).
fig. 1
fig. 2
3. Install Latch.
3.1 Latch is adjustable, you may set the latch to
either 2 ⅜” (60 mm) or 2 ¾” (70 mm) backset
(see fig.4).
3.2 Use faceplate as a pattern for mortise and
pilot holes. The faceplate should fit flush (see
fig. 5).
3.3 Install as shown for appropriate latch type.
Ensure bevel faces door jamb.
3.4 Check square hole edge on the latch
spindle. The square hole edges MUST are
either parallel or Vertically aligned with latch
centerline (see fig. 6), otherwise refer fig. 7 to
adjust latch spindle.
fig. 3
Loading ...
Loading ...
Loading ...