Loading ...
Loading ...
Loading ...
User Manual
57 / 68
waveform shapes buttons, this control sets the duty cycle of the signal. Duty cycle is defined as the time that the signal spends
above zero volts divided by the total cycle time. Thus, a symmetrical square or triangular wave has a duty cycle of 50%.
Reducing the duty cycle shortens the positive part of the cycle and lengthens the negative part, and increasing the duty cycle
does the opposite.
Note:
The Frequency, Amplitude, Offset parameter of the ARB waveform can not be regulated in this WaveEditor software, but it
can be done by tuning on the device directly (refer to above Chapter 3.1) after the waveform data is downloaded to device (refer
to below Chapter 3.3).
Do not use the WaveEditor and the DSO software at the same time, it will cause errors.
3.5. Output Arbitrary Waveform
1. Press the Wave Gen button on the front panel to enable the AWG function and enter the Wave Gen function menu.
2. Connect the device with PC which has installed the WaveEditor software using a USB cable.
3. Double click the WaveEditor icon to open the program.
4. Select a waveform file or draw an arbitrary waveform; then click the in toolbar and select waveform data download
position to download waveform data to the device.
The waveform will output from GEN OUT BNC port.
Also, you can recall ARB format file in USB disk to output a waveform.
Press the Wave Gen button on the front panel to enter Wave Gen function menu.
Press the Wave softkey, turn the Multifunctional Knob to select Arb1~Arb4 and then press the knob to confirm.
Press Recall softkey and select desired recalled ARB format file in USB disk.
The waveform will output from GEN OUT BNC port.
4. Remote Control
Connect the Type-A end of the USB cable to the computer, and connect the Type-B end to the USB port on the back of the
oscilloscope. A new device will be displayed in the computer device manager.
Loading ...
Loading ...
Loading ...