Hikvision DS-K3G501X User Manual

Loading ...

7.7.2 Congure Device Parameters

Aer adding the access control device, you can set its parameters

such as network parameters.

Set RS-485 Parameters

You can set the access control device's RS-485 parameters

including the baud rate, data bit, the stop bit, parity type, ow

control type, communicaon mode, work mode, and connecon

mode.

Before You Start

Add access control device to the client, and make sure the device

supports RS-485 interface.

Steps

1. Enter the Access Control module.

2. On the

navigaon bar on the le, enter Advanced Funcon →

More Parameters .

3. Select an access control device in the device list and click

RS-485 to enter the RS-485

Sengs page.

4. Select the serial port number from the drop-down list to set

the RS-485 parameters.

5. Set the baud rate, data bit, the stop bit, parity type, and

connecon mode in the drop-down list.

6. Click Save.

●

The congured parameters will be applied to the device

automacally.

●

When you change the connecon mode, the device will

reboot automacally.

Enable M1 Card Encrypon

M1 card encrypon can improve the security level of

authencaon.

Steps

Note

The funcon should be supported by the access control device

and the card reader.

1. Enter the Access Control module.

2. On the navigaon bar on the le, enter Advanced Funcon →

More Parameters .

3. Select an access control device in the device list and click M1

Card

Encrypon to enter the M1 Card Encrypon page.

4. Set the switch to on to enable the M1 card encrypon

funcon.

5. Set the sector ID.

The sector ID ranges from 1 to 100.

6. Click Save to save the sengs.

7.8 Door Control

In Monitoring module, you can view the real-me status of the

doors managed by the added access control device. You can also

control the doors such as open/close the door, or remain the

door open/closed via the client remotely. The

real-me access

Loading ...

Hikvision DS-K3G501X Pro Tripod Turnstile

User Manual - Page 65