Loading ...
Loading ...
Loading ...
The switching power supply can select the input voltage of 220 V
or 110 V by the DIP switch, and the default seng is 220V. Please
adjust the DIP switch based on the actual AC voltage to avoid
damaging the equipment.
Note
●
The cable bare part should be no more than 8 mm. If possible,
wear an insulaon cap at the end of the bare cable. Make sure
there's no bare copper or cable aer the wiring.
●
The Terminal L and the Terminal N cannot be wired reversely.
Do not wire the input and output terminal reversely.
●
To avoid people injury and device damage, when
tesng, the
ground resistance of the equipotenal points should not be
larger than 2 Ω。
4.4 Terminal Descripon
4.4.1 Lane Control Board Terminal Descripon
The lane control board contains power input interface, exit
buon and re input interface, access control board interface,
debugging port, indicator interface, etc.
The picture displayed below is the lane control board diagram.
4.4.2 Access Control Board Terminal
Descripon
Access control board is mainly used for authority idencaon in
places with high security levels such as public security or judicial
place, external device accessing, and
communicaon with the
upper plaorm and lane controller.
6
Loading ...
Loading ...
Loading ...