Loading ...
Loading ...
Loading ...
EMBROIDERY APPLICATIONS
86
l
Pass the yarn through the guide on embroidery
couching foot “Y”.
m
Thread the yarn through embroidery couching foot
“Y”.
Pass the yarn through the loop in the yarn threader,
and then pass the threader from top to bottom through
the hole in embroidery couching foot “Y”. Pull the
yarn to the front of the machine.
n
Touch to unlock all keys and buttons.
o
Thread the machine with the upper thread.
p
Press (Presser foot lifter button) twice to raise the
presser foot and then attach the embroidery frame to
the embroidery unit.
Embroidering a Couching Pattern
a
Touch .
b
Make sure that about 20 cm (approx. 8 inches) of yarn
is pulled to the front of the machine.
c
While holding the yarn in your hand in front of you,
press the “Start/Stop” button.
d
After embroidering several stitches, release the yarn.
When embroidering is finished, the machine will
automatically trim the threads and stop.
e
Cut the yarn, leaving about 20 cm (approx. 8 inches).
f
Punch a hole through the fabric with an awl or tapestry
needle and then use the yarn threader to pull the
excess yarn to the wrong side of the fabric.
g
Tie the end of the yarn so it cannot be pulled out, and
then use scissors to cut off any excess yarn.
Memo
• Place a sheet of paper under the presser foot to
smoothly pass the yarn threader through the hole in
embroidery couching foot “Y”.
Note
• Do not use the spool stand for upper thread.
Otherwise thread may tangle with yarn.
Memo
• For best results, use an upper thread that is the
same color as the yarn.
CAUTION
• Pulling the yarn upwards may cause it to catch
on the needle, causing it to break. Be careful
not to allow the yarn to catch on the needle.
Note
• Before embroidering, make sure that there is
enough yarn, upper thread and bobbin thread.
• Make sure that the yarn passes smoothly through
the guides. Unravel as much yarn from the ball as
necessary so that the yarn does not become taut.
• Use yarn that has no knots.
Memo
• When using a high-density yarn, the upper thread
tension may be disturbed. If this happens, it is
possible to improve it by raising the [Embroidery
Foot Height] by about 1 mm on the settings screen.
Loading ...
Loading ...
Loading ...