Loading ...
Loading ...
Loading ...
OMPDV288.book Page 5 Thmsday, June 16, 2005 t0:09 AM
Operating the Player
DVDs and CDs is located directly beneath the screen,
disc;
1, Press the OPEN button to open the receptacle.
2. Snap the disc onto the spindle in the center.
3. Close the receptacle cover. The player will begin to play the disc.
Adjusting the Volume
The VOL knob on the left side of the player sets the speaker and headphones
volume, To adjust the volume, swivel the knob in the appropriate direction.
Using Headphones
To listen to the audio using headphones, plug them into the PHONE jack on the
left side of the player. The speakers will mute when headphones are plugged
in.
Adjusting Color Settings
You can adjust display color settings with the buttons directly below the
player's screen. There are three color settings: Brightness, Contrast, and Color.
Press the MODE button to cycle through these, and press the DOWN and UP
buttons to adjust the selected setting.
To reset the color settings, press MODE until RESET is highlighted and press
either DOWN or UP.
The menu will disappear after a few seconds of inactivity.
Bringing Up the On-Screen Display
The On-Screen Display (OSD) gives information about the current disc and
playback. To bring up the OSD, press the OSD button on the remote.
Accessing the Setup Menu
The Setup menu allows you to configure the operation of the player. You can
change video, audio, and language settings, control access to mature
programming, and configure other general display behavior. See
"Configuring the Player" on page 27 for more information, To access the Setup
menu, press the SETUP button.
Loading ...
Loading ...
Loading ...