Loading ...
Loading ...
Loading ...
Installation Instructions
,,L,ii,u i i
'[_ INSTALLING THE ANTI-TIP DEVICE
WARNING!
m Range must be secured with an approved Anti-Tip
device
IWUnless properlg installed, the range could be
tipped bg gou or a child standing, sitting or leaning
on on open door
[] After installing the Anti-Tip device, verifg that it is
in place bg carefuttg attempting to tilt the range
forward
[] This range has been designed to meet al!
recognized industrg tip standards for all norma!
conditions
[] The use of this device does not preclude tipping
of the range when not properly installed
[] If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909
A_Hark the wall where the RIGHTEDGE of the range
is to be located Besure to allow for the countertop
overhang if gou intend to install the range next to
cabinets
B. Locate the outside edge of the device 2Ve" toward the
center of the range from the marked edge of the range
CoUsing the device as a template, mark the position of
the hole for the screw
DrFor wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal A nail or awI may
be used if a drill is not available
Haunt the Anti-Tip device with the screw provided
For cement or concrete construction, you will need
o 1/4" x 1W' lag bolt and a 1/2" O D sleeve anchor,
which are not provided Drill the recommended size
hole for the hardware
i
[] INSTALLING THE ANTI-TIP DEVICE
(CONT.)
B_ckd _ang_
Install the sleeveanchor into the drilled hole and then
install the lag bolt through the device, The bolts must be
propertg tightened as recommended for the hardware
E_Slide the range against the wall, and check for proper
installation bg grasping the front edge of the cooktop
and carefuIIg attempting to tilt the range forward
The bracket should stop the range within/4 inches
If it does not, the bracket must be reinstalled
WHEN ALL HOOKUPS ARE COMPLETED
Hake sure all controls are left in the off position. Hake
sure the flow of combustion and ventilation air to the
range is unobstructed..
CONVERTING TO LP GAS (or converting
back to natural gas from LP)
This range leaves the factorg set for use with natural
gas. If gou want to convert to LP gas, the conversion
must be performed bg a qualified LP gas installer,
The conversion instructions and LP orifices con be found
attached to the range next to the pressure regulator_
Keepthese instructions and the orifices in case gou want
to convert back to natura! gas
5!
Loading ...
Loading ...
Loading ...