Loading ...
Loading ...
Loading ...
Live Data Mode
CUSTOMIZING LIVE DATA (PIDs)
60
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press POWER/LINK
to continue.
If Live Data is not supported by the vehicle under test, an
advisory message displays. Press SYSTEM MENU
to return
to the System Menu.
If custom Live Data was previously configured, the Select PIDs
to Use screen displays.
- To use the existing custom Live data selections, select Use
existing PIDs, then press ENTER
. Proceed to step 5.
- To configure new custom Live
Data, select Select new PIDs,
then press ENTER
. The
Custom Live Data menu displays.
Proceed to step 3.
If custom Live Data was not
previously selected, the Custom
Live Data menu displays. Proceed
to step 3.
3. Press UP
and DOWN to scroll through the available PIDs.
When a PID you wish to display is highlighted, press ENTER
(a
"checkmark" shows to confirm your selection). Repeat until only the
PIDs you want to display have all been selected.
To deselect a PID, highlight the PID, then press ENTER .
The checkmark is removed.
4. When you are finished making your selection(s), press LD to
continue.
If no PIDs have been selected, an advisory message displays.
Press ENTER
to return to the Custom Live Data menu.
5. The Scan Tool is now in "Custom Live Data" mode. Only the PIDs
you selected are shown.
To change the current custom Live
Data selections, select Reselect
PIDs, then press ENTER
to
return to the Custom Live Data
menu. Repeat step 3.
6. To exit the "Custom Live Data" mode,
press LD to return to the Live Data
Menu.
Loading ...
Loading ...
Loading ...