Loading ...
Loading ...
Loading ...
Chrysler/Jeep OBD1 Systems
CODE RETRIEVAL PROCEDURE
26
3. Turn the ignition ON. DO NOT start the
engine.
The Chrysler Menu displays.
4. To retrieve codes from the vehicle’s
computer:
Press UP and DOWN buttons, as necessary, to
highlight the model year of the vehicle, then press ENTER
.
5. A “One moment please…” message shows while codes are being
retrieved.
If the Scan Tool fails to link to the vehicle’s computer, a “Commu-
nication Error” message shows.
- Verify the ignition is ON.
- Check the cable connections at the Scan Tool and at the
vehicle’s DLC.
- Turn the ignition OFF, wait 10-12 seconds, then turn back ON
to reset the computer.
- Press POWER/LINK
to continue.
If the Scan Tool cannot link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Press SYSTEM MENU
to return to the Chrysler Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
6. If the Scan Tool was able to link to the
vehicle successfully, the tool displays
the retrieved DTCs.
The Scan Tool will display a code only
if codes are present. If no codes are
present, the message “No DTCs are
presently stored in the vehicle’s
computer” displays.
7. If more than one code was retrieved press DTC/FF, as necessary,
to display additional codes one at a time.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information.
8. Disconnect the Scan Tool from the vehicle and turn the ignition key
OFF.
9. To prolong battery life, the Scan Tool automatically shuts "Off" after
approximately three minutes of no button activity. The DTCs
retrieved will remain in the Scan Tool's memory, and may be viewed
at any time. If the Scan Tool’s batteries are removed, or if the Scan
Tool is re-linked to a vehicle to retrieve codes, any prior codes in its
memory are automatically cleared.
Loading ...
Loading ...
Loading ...