Loading ...
Loading ...
Loading ...
Using the Scan Tool
VIEWING TPMS DTCs
18
To exit the enhanced mode, press SYSTEM MENU to return
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.
VIEWING TPMS DTCs
Refer to the manufacturer’s website for vehicle makes covered.
Reading TPMS DTCs
1. When TPMS DTCs is chosen from the System Menu, a "One
moment please" message displays while the Scan Tool retrieves the
selected DTCs.
If TPMS functionality is not supported, an advisory message
shows. Press SYSTEM MENU
to return to the System Menu.
If the Scan Tool fails to link to the vehicle’s computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press POWER/LINK
to continue.
If the Scan Tool cannot link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Press SYSTEM MENU
to return to the System Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
2. Refer to DISPLAY FUNCTIONS on
page 3 for a description of LCD display
elements.
If the definition for the currently
displayed code is not available, an
advisory message shows.
I/M MONITOR STATUS icons are not
displayed when viewing SRS DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information.
If no codes are present, the message "No TPMS DTC’s are
presently stored in the vehicle’s computer" shows.
3. If more than one code was retrieved press DTC/FF to display
additional codes one at a time.
Loading ...
Loading ...
Loading ...