Loading ...
Loading ...
Loading ...
EN
2-Installation
2.7 Fresh Water Connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled
end to the appliance (Fig. 2-8). Tighten the
screw joint by hand.
2. The other end connect to a water tap with a
3/4“ thread (Fig.2-9).
2-92-8
9
Following connections are possible:
2.6.1 Drain hose to sink
▶ Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 2-5).
▶ Protect the U-support suffi ciently against slip-
ping.
2.6.2 Drain hose to waste water connection
▶ The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶ Put the drain hose for approx. 80-100 mm in the
wastewater pipe.
▶ Attach the U-support and secure it suffi ciently
(Fig. 2-6).
CAUTION!
▶ The drain hose should not be submerged in water and should be securely fixed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being filled (self-si-
phoning).
▶ Drain hose is not to be extended. If necessary contact after sales service.
2.6.3 Drain hose to sink connection
▶ The junction must lie above the siphon
▶ A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 2-7).
▶ Secure the drain hose with a clamp.
2-6
2-5
2-7
Loading ...
Loading ...
Loading ...