Loading ...
Loading ...
Loading ...
12
MOUNT THE SENSOR OUTDOORS
If securing to a railing, make sure the railing is made of suitable material, and screw directly through
the openings in the base stand into the railing until secure.
1. The wireless weather sensor should be mounted in an open area with no obstructions above and/
or around it, so that it can accurately measure the rain and wind.
2. The wind vane should be pointed due North (refer to the arrow on top of the unit) in order to be
properly oriented and receive accurate wind readings.
3. The mounting stand and included clamps should be secured to a post or pole, with a minimum of
4.9 ft. (1.5 m) ground clearance.
4. If securing to a pole, make sure you add the rubber pads to the clamp before fastening it with the
included screws. The pole should be between 1″-1.3″ in diameter.
4. Insert the nut into the hexagonal hole on the side of the stand and hold it in place, then insert the
screw through the other side. Use a screwdriver to tighten the screw.
Install the wireless 5-IN-1 sensor in an
open location with no obstructions above
and around the sensor for accurate
rain and wind measurement. Install
the sensor with the smaller end facing
the North to properly orient the wind
direction vane.
Secure the mounting stand and bracket
(included) to a post or pole, and allow
minimum 1.5m off the ground.
1.5 meter off
the ground
Add rubber
pads before
mount on
the pole
Point to
NORTH
Your console can pairing up with the wireless 5-IN-1 outdoor weather sensor and up to 7
optional wireless sensors. (Not included)
Remove the battery door of the console.
Insert a new button cell battery.
Replace the battery door.
The backup battery can backup: Time & Date, Max/Min & Past 24 hours weather records, Alert
setting values, offset value of weather data and Sensor(s) channel history.
The built-in memory can backup: Router setting and Weather server setting
Plug the power adaptor to power up the console.
Once the console power up, all the segments of the LCD will be shown.
The console will automatically start AP mode.
If no display appears on the LCD after you plug the adaptor, press key by using a
pointed object.
key in normal mode to adjust LCD viewing angle to t table stand or wall
mount situation.
A
MOUNTING ON POLE
(POLE DIAMETER 1”-1.3”)
(25-33MM)
Point to NORTH
Add rubber
pads before
mount on
the pole
1.5 meter off the
ground
Loading ...
Loading ...
Loading ...