Loading ...
Loading ...
Loading ...
18
Figure 4-16 Lane property
Table 4-7 Lane property description
Parameter Description
Road Direction The direction of the lane.
RoadDirection The geographical direction of the lane.
Roadway Code
The code of the roadway and route.
Route Code
Step 4 Click
Confirm
.
Car Detect
Draw the regions for vehicle detection on the image.
Step 1 Select
Setting
>
Event
>
ANPR Snap
>
Illegal Capture
.
Step 2 In the
Car Detect
section, click a line or region type, and then draw on the video image.
●
To draw a line, click the line type, and then draw on the image.
●
To draw a region, click the region type, and then click on the image to set the four
points of the region.
To clear the lines that you have drawn, click .
Figure 4-17 Line or region types
Table 4-8 Car detect description
Parameter Description
Region The region of detection.
Car Region The region for detecting vehicle volume.
Match Line
When the radar inside the Device detects an event around the match
line, it sends a signal to the Device to take a snapshot.
Step 3 Click
Confirm
.
Rule Configuration
For the selected lane in the
Lane Config
section, you can select the traffic violation types and
configure the corresponding parameters of the snapshot, trigger source and flashing light.
Step 1 Select
Setting
>
ITC
>
ANPR Snap
>
Illegal Capture
.
Step 2 Select a lane from the list under
Lane Config
.
Step 3 In the
Rule Config
section, select of an event, and the click the corresponding to
configure the snapshot parameters.
Loading ...
Loading ...
Loading ...