Loading ...
Loading ...
Loading ...
17
You can also click next to
LaneLine
or
Detect Line
to delete the corresponding
lines on the image.
2. Click
LaneLine
or
Detect Line
, and then draw lines on the image.
When a vehicle reaches the detection line, a snapshot is triggered.
●
If the default lane lines can be adjusted to match the actual lane lines, you can adjust
them.
1. Select
Graphic Adjustment
to enable lane line adjustment, and then select a lane
from the list.
2. Drag to adjust the lane lines and detection lines according to the actual situation.
Figure 4-15 Lane configuration
Step 3 For the selected lane, select
Lane Direction
and
Flow
.
●
Lane Direction
: The direction of the lane line on the image needs to be the same as
that of the travelling vehicle.
●
Flow
: Select the capturing part of the vehicle and its traveling direction. This is normally
used for traffic flow analysis.
Step 4 Double-click the selected lane on the list under
Left Lane Line Type
,
Right Lane Line
Type
and
CarWay Type
to change the lane lines and lane type as needed.
●
Click to display or hide the corresponding lanes on the image.
●
Click to select a lane for the Device to monitor and detect events on.
●
Click to delete the corresponding lane lines on the image.
Step 5 Click
Confirm
.
Lane Property
For the selected lane in the
Lane Config
section, you can set its road direction and code.
Step 1 Select
Setting
>
Event
>
ANPR Snap
>
Illegal Capture
.
Step 2 Select a lane from the list under
Lane Config
.
Step 3 In the
Lane Property
section, configure lane properties.
Loading ...
Loading ...
Loading ...