Loading ...
Loading ...
Loading ...
62
EAD10 Owner’s Manual
Message List
Reference
*1 Refer to the website at http://download.yamaha.com/
*URL may change without notice.
Please stop recorder. Appears when performing an operation that exits the Recorder dur-
ing recorder playback or recording. Stop the Recorder and try again.
Recording time limit exceeded. Recording time is about 1 minute 30 seconds with internal memory,
and about 30 minutes with a USB flash drive.
Read only file. Appears when a read-only file is selected during a file operation.
Sample is too long. Sample is too long and cannot be loaded.
Sample is too short. Sample is too short and cannot be loaded.
Switch to AUX IN recording? Appears when the button below “source” is pressed while using the
recorder. Press the button below “YES” and switch to recording from
the [AUX IN] jack.
USB connection terminated. Appears if connection with the USB device was interrupted by an
abnormal electric current. Disconnect the USB device and press the
button below “OK”.
USB device’s transfer speed too slow. Appears when the transfer speed to the USB device is insufficient.
For information on devices that have been tested and confirmed to
work properly with the EAD10, refer to the “Compatible USB Device
List”
(*1)
on the Yamaha web site.
USB device full. Appears when the USB device is full and files cannot be saved on it.
Use a new USB device or make space by erasing unnecessary files
from the full device.
USB device not ready. Appears if the USB device is not properly connected to the Main
Unit.
USB device read/write error. Appears if an error occurred while reading or writing data to the USB
device.
USB device write protected. Appears if the USB device is write-protected.
USB transmission error. Appears if an error occurred while communicating with the USB
device.
Wave memory full. Appears if the WAVE memory is full and operations such as Import,
Job, or Load cannot be carried out.
Message Description
Loading ...
Loading ...
Loading ...