Loading ...
Loading ...
Loading ...
18
EAD10 Owner’s Manual
Setting Up
Setup Guide
Attaching the Sensor Unit
Attach the Sensor Unit to the top of the batter side bass drum hoop.
Standard Straight Hoop
1.
Slide the Sensor Unit onto the top of the batter side bass drum hoop as far as possible.
2.
Lift the Sensor Unit and after making sure both surfaces shown in the figure below are in
contact with the hoop, turn the clamp screw.
Tighten the clamp screw firmly, making sure that the Sensor Unit is secure and not loose.
Other Hoop Types
1.
Attach the included adhesive cushions,
one each to the top of the inner and
outer hoop surfaces.
2.
Attach the sensor using the same procedure as for a standard hoop drum.
NOTICE
Make sure the uneven surface is filled with adhe-
sive cushions to provide a secure attachment for
the sensor. The Sensor Unit may fall off if the
adhesive cushions is not used.
Wood hoops
12
Side view
Top of the
batter side
Hoop
Make sure these two
surfaces are in con-
tact with the hoop
Make sure this sur-
face is in contact
with the hoop
Clamp
screw
Adhesive
cushion
(cross section)
Uneven profile type
Metal hoops
(cross section)
Loading ...
Loading ...
Loading ...