Loading ...
Loading ...
Loading ...
SIGLENT
102 SDS1000CML+/SDS1000DL+ User Manual
2.13.9 Remote Control
There are two means to remotely control the oscilloscope:
Use user-defined programming
User can control the oscilloscope by programming through standard SCPI
(Standard Commands for Programmable Instruments) commands. For more
details about commands and programming, Please refer to Programming Manual.
Use PC software offered by SIGLENT or other manufacturers
User can send command to remotely control the oscilloscope through PC software
EsayScope which offered by SIGLENT. Besides, “Measurement & Automation
Explorer” which provided by NI (National Instruments Corporation) also can be
used to control the oscilloscope. This oscilloscope can communicate with a PC by
a USB bus. This part will show how to use EsayScope to remotely control an
oscilloscope by USB interface.
Control by USB
Connect Instrument
Use a USB data wire to connect the oscilloscope (USB Device) to a PC.
Installing USB Device
Set oscilloscope Back USB to USBTMC. If you have installed EsayScope or NI
software, the PC will pop-up a hardware update guide dialogue box which shows
below when you connect the oscilloscope to the computer correctly for the first
time, and please install the “USB Test and Measurement Device” device program
follow the prompting messages. Below are the steps:
Loading ...
Loading ...
Loading ...