Loading ...
Loading ...
Loading ...
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
ー
Hand movement operation is in
progress
Configuring the Auto Light
Setting
Holding down (L) for at least three seconds in
the Timekeeping Mode will toggle Auto Light
between enabled and disabled.
●
[LT] is displayed while Auto Light is
enabled.
●
If you do not disable it manually, Auto Light
remains enabled for approximately six
hours. After that, it becomes disabled
automatically.
On
Specifying the Illumination
Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the Step
Reminder setting screen ([OFF] or [ON]
flashing) appears.
3. Press (C) 10 times to display [LT].
4. Press (D) to toggle between the two
illumination duration settings.
[1]: 1.5-second illumination
[3]: 3-second illumination
5. Press (A) to exit the setting screen.
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Getting Ready
Enter the Timekeeping Mode.
l
Navigating Between Modes
Adjusting Hand Alignment
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least five seconds.
Release the button when [12:00] starts to
flash.
This enables adjustment of the hour and
minute hands.
After five secondsAfter two seconds
3. If the hour hand and minute hand are not
at 12 o’clock, use the (D) and (B) buttons
to align them.
4. Press (A) to exit the setting screen.
Battery Replacement
When battery power goes low, will start to
flash and some functions will become
disabled. If continues to flash, replace the
battery.
Other Settings
Getting Ready
Enter the Timekeeping Mode.
l
Navigating Between Modes
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the Step
Reminder setting screen ([OFF] or [ON]
flashing) appears.
3. Press (C) nine times to display [♪].
4. Press (D) to toggle the button operation
tone between enabled and disabled.
[On]: Operation tone enabled.
[OFF]: Operation tone disabled.
5. Press (A) to exit the setting screen.
Operation Guide 5556
19
Loading ...
Loading ...
Loading ...