Loading ...
Loading ...
Loading ...
Note
●
A record of the measured data is
created and assigned a number for
each measurement operation (from
start to stop).
Deleting a Particular Record
Use the procedure below to delete a selected
data record.
1. Enter the Recall Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
●
Holding down (A) switches the record
number.
Record number
3. Hold down (B) and (D) at the same time
for at least two seconds. Release the
buttons when [CLR] stops flashing.
●
This deletes the displayed data.
Note
●
You cannot delete data while an
elapsed time measurement operation
is in progress.
Deleting All Records
You can use the procedure below to clear all
data records in watch memory.
1. Enter the Recall Mode.
l
Navigating Between Modes
2. Hold down (B) and (D) at the same time
for at least five seconds. Release the
button when [ALL CLR] stops flashing.
[CLR] flashes and then stops flashing to
indicate that the displayed data record
was deleted. Keeping the buttons
depressed will cause [ALL CLR] to flash
on the display. [ALL CLR] will stop
flashing to indicate that all data records
have been deleted.
Note
●
You cannot delete data while an
elapsed time measurement operation
is in progress.
Timer
The timer counts down from a start time
specified by you. The watch beeps every
second for the last five seconds of the
countdown.
●
The beeper is muted in the cases described
below.
ー
When battery power is low.
Getting Ready
Enter the Timer Mode.
l
Navigating Between Modes
Setting a Timer Start Time
A timer start time can be set in 1-second units
up to 60 minutes. The procedure below shows
how to configure a single timer for a
countdown.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Hold down (A) for at least two seconds.
Release the button when the number of
timer auto repeats setting (01 to 20) starts
to flash.
Number of repeats
2. Use (D) and (B) to specify [01] as the
number of timer auto repeats.
Number of repeats
3. Press (C).
4. Use (D) and (B) to display [1].
5. Press (C).
This causes the minutes digits to flash.
6. Use (D) and (B) to change the timer
minutes setting.
Minutes
7. Press (C).
This causes the seconds digits to flash.
8. Use (D) and (B) to change the start time
seconds setting.
Seconds
9. Press (A) to exit the setting screen.
Operation Guide 5556
14
Loading ...
Loading ...
Loading ...