Loading ...
Loading ...
Loading ...
en Steam
20
2.
Remove the water tank from the tank recess.
3.
Fill the water tank with cold water up to the "MAX"
mark.
4.
Place the water tank into the tank recess and slide it
in fully.
5.
Close the tank cover.
11.7 Refilling the water tank
Notes
¡ The way the appliance responds if the water tank
runs dry when the appliance is in operation
depends on what operating mode it is in:
– Steam operation: The appliance interrupts the
operation. The display shows a message. At the
highest steam setting, a tankful of water will last
around 30-40minutes; at the lower steam set-
tings, it will last much longer.
– Steam with microwave: The appliance interrupts
the operation. A tankful of water will last around
50minutes.
– Grill with steam: The appliance continues to oper-
ate using the grill. No message appears on the
display. At the highest steam setting, a tankful of
water will last around 3hours; at the lower steam
settings, it will last much longer.
¡ Actual times may vary from those specified.
1.
Open the control panel.
2.
Remove the water tank.
3.
Fill the water tank up to the "MAX" mark.
4.
Insert the full water tank and close the control panel.
11.8 After using steam operation
Moisture will remain in the cooking compartment. Care-
fully wipe out the drip trough and the cooking compart-
ment.
Each time you cook using steam, we recommend that
you run the Rinse cleaning function. Then empty and
dry the water tank and drip tray.
Note:Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a soft
cloth.
Rinsing the appliance
To ensure that your appliance stays clean, you can
pump water through the pipe system. The appliance
then drains the water into the drip tray.
Note:After running the rinse cycle, loosened limescale
particles may be in the collecting container. This is nor-
mal and does not affect operation.
1.
Use the function selector to select .
a The display shows the programme duration. You
cannot change the duration.
2.
Open the tank cover.
3.
Remove the drip tray and empty it.
4.
Slide the empty drip tray in fully.
5.
Remove and empty the water tank and drain any re-
sidual water.
6.
Rinse out the water tank thoroughly and fill it with
fresh water.
7.
Slide the water tank in fully.
8.
Close the tank cover.
9.
Press .
a The appliance pumps water through the pipes.
a The time remaining counts down in the display.
a An audible signal sounds once this time has
elapsed.
10.
Empty the drip tray.
Loading ...
Loading ...
Loading ...