Loading ...
Loading ...
Loading ...
144
Setup
Hardware
Power Management
Change the settings for the power-save function.
Sleep Timer (Default Value: Off)
30 minutes,
60 minutes,
90 minutes
You can allow the unit to enter standby automatically when
the specied time elapsed. Select a value from "30 minutes",
"60 minutes" and "90 minutes".
Off Does not turn the unit to standby automatically.
Auto Standby (Default Value: On/Off)
This setting allows the unit to enter standby mode automatically after 20
minutes of inactivity without any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled, the unit enters the HYBRID
STANDBY mode which minimizes the increase in power consumption.)
• Default values vary depending on the regions.
On The unit will automatically enter standby mode ("AUTO STBY"
will light).
• "Auto Standby" is displayed on the main unit’s display and
TV screen 30 seconds before entering standby mode.
• "Auto Standby" does not work when Zone 2/Zone 3 is active.
Off The unit will not automatically enter standby mode.
Auto Standby in HDMI Standby Through (Default Value: On/Off)
Enable or disable "Auto Standby" while "HDMI Standby Through" is on.
• Default values vary depending on the regions.
On The setting will be enabled.
• This setting cannot be set to "On" if "Auto Standby" and
"HDMI Standby Through" are set to "Off".
Off The setting will be disabled.
USB Power Out at Standby (Default Value: Off)
Devices connected to the USB port (5 V/1 A) on the rear of the unit can be
supplied with electricity even when this unit is in standby mode when this
function is "On".
• Supply of power to USB devices in the standby mode is not supported for the
USB port on the front panel.
• When this function is set to "On", the power consumption in standby state
increases, however, the increase in power consumption is minimized
by automatically entering the HYBRID STANDBY mode where only the
essential circuits operate.
Loading ...
Loading ...
Loading ...