Loading ...
Loading ...
Loading ...
unpacking and assembly
UNPACKING AND PREASSEMBLY
WARNING: DO NOT CONNECT THE POWER CORD TO
A SOURCE OF POWER. THIS CORD MUST REMAIN
UNPLUGGED WHENEVER YOU ARE WORKING ON
TH E SAW.
1. Unpacking and Checking Contents
Separate all "loose" parts from packaging materials and
check each item with "Table of Loose Parts" to make
sure all items are accounted for, before discarding any
packing material.
If any parts are missing, do not attempt to assemble the
radial saw, plug in the power cord or turn the switch on
until the missing parts are obtained and installed correctly.
Key No.
(Fig. 1) Table of LooseParts Qty.
1
2
3
4
5
6
7
8
Basic Saw assembly ...................... 1
Rear table ............................. 1
Table spacer ........................... 1
Rip fence ............................. 1
Front table ............................ 1
"Owner's Manual" . ..................... 1
Channel, Table Mtg...................... 2
Loose Parts Bag Part No. 63510
(containing the following items):
Hex-" L" Wrench, 1/8". ................. 1
Hex-"L" Wrench, 3/16". ................ 1
Elevation crank assembly ................ 1
Switch key ........................... 2
Arbor Wrench ........................ 1
Table clamp .......................... 2
Rip-scale indicator ..................... 1
Twin nut (for attaching rip-scale indicator) .. 1
4
CARRIAGE BOLT
_(4 USED - DISCARD)
Machine screw, pan-hal., 1/4-20 x 1" . ...... 4
Washer, steel (flat), 17/64 x 5/8 x 1/32" .... 5
Machine Screw, pan-hd., 1/4-20 x 1-1/4".... 1
Screw Slotted set 1/4-20 x 1/2". .......... 1
Nut Tee ............................. 1
Machine screw, pan-hd., 6-32 x 7/16" . ..... 2
Shaft wrench ......................... 1
Screw, Hex hd., 5/16-18 x 1/2 ........... 4
Lockwasher, 5/16 ..................... 4
Washer, Flat, 11/32 x 7/8 x 1/16 .......... 4
Washer, Flat, 5/16 x 9/16 x 1/16 .......... 2
Nut, Lock, 5/16-18 .................... 2
Nut, Speed ........................... 4
REMOVE SKIDS FROM BASE
MOUNT SAW TO CRAFTSMAN BASE OR
LEG SET, OR FLAT BENCH
(NOT SUPPLIED IN CANADA)
Make sureelevation crank isfree to rotate. The saw must be
bolted down. Position your entire saw (or saw bench) to
slope slightly rearward, so the carriage wiU not roll forward
due to gravity.
Loading ...
Loading ...
Loading ...