Loading ...
Loading ...
Loading ...
unpacking and assembly
2. Position arm at approximately 30 ° miter setting and
lock arm lock knob. Loosen arm lock knob 1/4 turn
and index arm at 0° miter setting. Push the arm latch
solidly with palm of hand ... this will seat the arm
index pin properly.
ARM LATCH LEVEl
ARM LATCH KNOB
3. While holding the arm latch knob with one hand, hold
fingers of other hand as shown, between column tube
and column support. Apply gentle side force to the
radial arm in opposing directions. Any looseness
between column and column support, (indicated by
arrow) can be felt with fingers.
Right and left positions are given with operator facing the
saw - standing in front of the saw table.
4. If looseness can be felt, perform operations as follows:
a.
b.
C.
Loosen set screw in center of column tube key.
Loosen left hand set screw 1/4 turn.
Tighten right hand set screw until looseness
between column and column support is eliminated.
Turn elevation crank to raise radial arm, if saw
elevates too hard, loosen right hand set screw
slightly and again check elevation and column tube
for looseness. When correct, tighten left hand set
screw.
d.
Tighten set screw in center of column tube key.
Elevate and lower arm if chatter or rough elevation
exists, tighten set screw until smoothest operation is
obtained.
e. Turn elevation crank to raise and lower radial arm.
If too tight, loosen right hand set screw slightly and
STEP THREE
SQUARING CROSS CUT TRAVEL
TRAVELS IN A STRAIGHT LINE).
(CARRIAGE
1. Lower arm until saw blade just clears the front table.
Lock the yoke clamp handle and bevel lock knob.
2. Place a framing square on the table as shown and
position the blade and square until the leg of the square
just contacts a tooth of the blade. Mark this tooth.
3. When the carriage is moved back and forth on the radial
arm, the marked tooth should just touch the square at
all points. If marked tooth does not touch the square at
all points, make the following adjustments:
10
COLUMN TUBE
FRICTION PLUG
(NYLON)
COLUMN
SUPPORT
SET
SACK-UP PLUG
(STEEL]
SET SCREW
(LEFT HAND)
\
COLUMN TUBE KEY
SECTIONAL VIEW LOOKING gOWN
check again for smooth operation. When correct,
tighten left hand set screw.
Tighten set screw in center of column tube key
until smoothest operation is obtained.
____ ARM LATCH KNOB
Loading ...
Loading ...
Loading ...