Loading ...
Loading ...
Loading ...
24
Fitness Bike
CR800
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufciently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a larger wrench
than the one provided if you cannot tighten the bolts sufciently. I cannot stress this point enough; 90% of
calls to the service department for noise issues can be traced to loose hardware or the rear rails
being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from build-up
on the rails can cause a thumping sound that you would swear is coming from inside the main body of the
machine because noise travels, and is amplied, in the tubing of the frame. Clean the rails and wheels with
a lint free cloth and rubbing alcohol. Stubborn build-up can be removed with your thumbnail or a non-
metallic scraper, like the back edge of a plastic knife. After cleaning, apply a small amount of lubricant on
the rails with your ngers or a lint free cloth. You only need a thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 4 leveling pads on the bot-
tom of the rear rails, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key
is pressed for example. To enter the Engineering Mode Menu, press and hold down the Start,
Stop and Enter keys. Keep holding the keys down for about 5 seconds and the Message
Center will display Engineering Mode Menu. Press the Enter button to access the menu below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. Security (Allows you to lock the keypad so no unauthorized use is allowed; Off; to turn On, press LevelUp,
then the Enter key)
c. Functions (Press Enter to access settings)
i. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)
ii. Elliptical or Bike (Sets the console software calculations)
iii. DA Test (Tests the brake resistance)
iv. Beep (Turn on or off the beep when a key is pressed)
v. Units (Set to English or Metric display readings)
vi. Odometer Reset (Resets the odometer)
vii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indenitely)
d. Display Test (Tests all the display functions)
General Maintenance
Engineering Mode Menu
Loading ...
Loading ...