Loading ...
Loading ...
Loading ...
5
GENERAL CAUTIONS
Causes of damage
CAUTION
• Metal - e.g. a spoon in a glass - must be kept at least
2cm from the oven walls and the inside of the door.
Sparks could irreparably damage the glass on the
inside of the door.
NOTE: The wire grill racks supplied with this
appliance are compatible for use on microwave
mode. Please ensure only the supplied wire grill racks
are used, and they must be placed centrally on the
turntable during use.
• Never pour water into the hot cooking compartment.
This will cause steam. The temperature change can
cause damage.
• Do not store moist food in the closed cooking
compartment for long periods. Do not use the
appliance to store food. This can lead to corrosion.
• Only allow the cooking compartment to cool with the
door closed. Do not trap anything in the appliance
door. Even if the door is only slightly ajar, the fronts of
adjacent units may be damaged over time.
• If the seal is very dirty, the appliance door will no
longer close properly during operation. The fronts of
adjacent units could be damaged. Always keep the
seal clean.
• Operating the appliance without food in the cooking
compartment may lead to overloading. Never switch
on the appliance unless there is food in the cooking
compartment. An exception to this rule is a short
crockery test (see the section “Microwave, suitable
crockery”) .
• Do not stand or place anything on the open
appliance door. Do not place ovenware or
accessories on the appliance door.
• Do not carry or hold the appliance by the door
handle. The door handle cannot support the weight
of the appliance and could break.
• Liquid that has boiled over must not be allowed to
run through the turntable drive into the interior of the
appliance. Monitor the cooking process. Choose
a shorter cooking time initially, and increase the
cooking time as required.
• The oven should be cleaned regularly and any food
deposits removed since it will reduce the efficiency of
the microwave.
• Failure to maintain the oven in a clean condition
could lead to deterioration of the surface that could
adversely affect the life of the appliance and possibly
result in a hazardous situation .
INSTALLATION
Fitted units
• This appliance is only intended to be fully built in to
a kitchen.
• This appliance must not be installed behind a
decorative door in order to avoid overheating
• This appliance is not designed to be used as a
tabletop appliance or inside a cupboard.
• The fitted cabinet must not have a back wall behind
the appliance.
• A gap of at least 45mm must be maintained between
the wall and the base or back panel of the unit above.
• The fitted cabinet must have a ventilation opening of
250 cm
2
on the front. To achieve this, cut back the
base panel or fit a ventilation grille.
• Ventilation slots and intakes must not be covered.
• The safe operation of this appliance can only be
guaranteed if it has been installed in accordance with
these installation instructions.
• The fitter is liable for any damage resulting from
incorrect installation.
• The cabinetry into which the appliance is fitted must
be heat resistant up 90°C.
• If the appliance is installed on a base, measures must
be taken to prevent the appliance from slipping from
the base.
Loading ...
Loading ...
Loading ...