DLE0332W Owner's Manual

Loading ...

Step 4: (Electric Dryer Only) Connect

Electrical Plug

For furlher assistance refer to section on Electrical

Requirements.

IMPORTANT : U_ only a new U.L. li_t,d No. 10

(copper wire only) three conductor _)wer supply

cord kit rat,._'l 240 Volts (minimum)30 Amper¢_

and labeled a:ssuitable for use in a clothes dryer.

NOTE : For more de_iled information on

conn_ction three=wire or four-wire plugs, refer to

s_etion on Fdectric Dryer Fdectrical Requirements.

NOTE : Four-wire cord is required for nmbile

homes or where c_'les do not __it grounding

Step 5: Wipe Out Inside of Dryer

Belbre using dryer for the fi_t timc, use an all-purpo_

clcancr, or a detc_Nent and water _lufion, and a damp

cloth to remove shipping dust from inside the drycr

drt|lll.

Heat Source Check

El_tric Dryers

Close the loading door and start the dryer in a heat

setting (ml_r to the ()perating Inslructions suppli_ with

the dryer). After the d_'cr has operated l;:_rfllree minutes,

the exhaust air or exhaust pipe should bc warm.

Gas Dryers

Close the loading door, start the dryer in a heat _tting

(rct;cr to the Operating Instructions supplied with the

dryer); the dryer will start, the igniter will glow red and

the main burner will ignite.

IMPORTANT : If all air is not purged out of the gas

line, the ga_sigmiter may go off before gas it is ignited.

If this happens, aher approximately two minutes the

igniter will ag_n attempt ga_ ignition.

Step 6: Plug In the Dryer

Refer to section on Electrical Requirements, ;rod

COlmect the dryer to an electrical l_)wer sxmrce.

Step 7: Check Installation

Loading ...

Owner's Manual - Page 9