Loading ...
Loading ...
Loading ...
Lubrication
All moving p_uls arc sealcd in a t_rma'lent supply of
lubricant or arc _uipped wilh oilless bearings.
Additional lu_icalion will not _ nccess_y.
Care of Your Dryer
Cle_m the lint :filler _:fore drying each load, The lint
filter may be washed if needed, Annually remove lhe lint
filter and allach Io the wlceuum dnet under it.
O:_inarily, the dryer cylinder will need no care,
Wipe the exlerior d_Ter cabinet as needed iffdetergent,
bleach or oilier washing p:r_ducts arc spilled on the
cabinet, wipe immediately. Some p:mducts will c_mse
l_rmanent damage if spilled on the cabineL
Use only a damp cMth lbr clemfing lhe conh'ol pancl.
Some spray prewash prc_ucls may h_uln ihc firfish on lhe
control panel.
©ieaning lhe Lint Screen
Every load cleaning
The lint screen is located in the door opening of the
dryer. Clean it before or after each load. A screen
blocked by lint can increase drying time.
To clean
NOTE: The wiring diagram is local,,xi inside the
control panel.
i. Pull the lint screen straight up. Roll lint off the
screen with your fingers. Do not rinse or wash
screen to remove lint. Wet lint is hard to remove.
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
2. Push the lint screen firmly back into place.
IMPORTANT:
[]
[]
Do not run the dryer with the lint screen ioose,
damaged, blocked, or missing. Doing so can cause
overheating and damage to both the dryer and
fabrics.
[]
Some towels made of synthetic fibers and natural
fibers (polyester and cotton blends) may shed more
lint than other towels, causing your dryer's lint
screen to fill up faster. Be sure to remove lint from
the lint screen before and after drying new towels.
If lint falls off the screen into the dryer during
removal, check the exhaust hood and remove the
lint,
As ne_ed cleaning
Laundry detergent and fabric softener residue can
build up on the lint screen. This buildup can cause
longer drying times for your clothes, or cause the dryer
to stop before your load is completely dry. The screen
is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every six
months, or more frequently, if it becomes clogged due
to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3.
Wet a nylon brush with hot water and liquid
detergent. Scrub lint screen with the brush to
remove residue build up.
4. Rinse screen with hot water.
5. Completely dry lint screen with a clean towel
Replace screen in dryer.
Loading ...
Loading ...
Loading ...