Loading ...
Loading ...
Loading ...
Step I : Position and Level the Dryer
l:or fu_her assistance refer to section on Location
Requirements.
Place the dryer in lx)sition, and adjust the legs until the
dryer is level :fron_side: to side and fi_mt to back,
[vvel :fl_×_r: Maximum slope under emire dwcr should
not be more tlmn 2.5cm (1 inch), If slope is greater than
2.5 cm (I inch), clothes may not tumNe proFvfly and
_mtomatic sensor cycles may not ot_mte correctly if
dryer is not level,
Step 2 : Conn_t Dryer Exhaust System
For t!urther assistance refer to _ctions {m Ix)cation
Requirements and Dryer Exhaust Requirements.
• DO NOT use plastic or thin foil ducting.
• Locate dryer so exhaust duct is as short as
possible.
• Be certain old ducts are cleaned before installing
your new dryer.
• Use 4" (10.2 cm) diameter rigid or flexible metal
duct.
• The male end of each section of duct must point
away from the dryer.
• Use as few elbows as possible.
• Use duct tape on all duct joints.
• Ductwork that runs through unheated areas must
be insulated to help reduce condensation and
lint build-up on pipe walls.
• Failure to exhaust dryer properly will void
A clothes dryer produces combustible lint.
To reduce the risk of fire and combustion
gas accumulation the dryer MUST be
exhausted to the outdoors,
NOTE : Venting materials are not supplit_l with the
dryer (obtain locally).
Loading ...
Loading ...
Loading ...