Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. G | EN10/23/2023Page 62 of 100
DRAFT TOWER CLEANING
Regardless of design, draft dispensers must be
cleaned regularly. Flushing the draft dispenser with
only water is not enough to maintain cleanliness. True
recommends cleaning the draft dispenser whenever
changing to a fresh keg.
Clean dispensers ensure your draft beer will be at its
best when served. Although the beer in the barrel
is in excellent condition, the beer can become less
satisfying if drawn through a dirty beer line and faucet.
NOTE: USE CLEANERS APPROVED BY
YOUR BEER SUPPLIER AND FOLLOW THEIR
INSTRUCTIONS. IF YOU ARE USING THE
CLEANING KIT PURCHASED FROM TRUE
FOLLOW THE INSTRUCTIONS BELOW.
Cleaning kit available at
store.trueresidential.com/collections/maintenance-1/
products/beer-line-cleaning-kit
Cleaning solution available at
store.trueresidential.com/collections/maintenance-1/
products/beer-line-cleaning-solution
Prepare Solution:
Add 1/2 ounce (19 grams) of cleaning solution to each
quart of warm water. Fill pump bottle with the mixed
cleaning solution.
Beer Cleaning instructions:
1. Shut-off the CO
2
at the regulator.
2. Remove the tapping device (keg coupler)
from the keg.
3. Unscrew handle from faucet.
4. Remove beer faucet with spanner wrench
(turn clockwise to remove). See image 1.
5. Put tap and faucet parts in a bucket.
6. Thread hose from pump bottle to beer column tap
outlet (be sure rubber gasket is in place to prevent
leakage) – allow beer line to drain in bucket.
See Image 2.
7. Pump solution from bottle through the beer line(s)
into the bucket. Wait 10 minutes while cleaning
solution works through the lines.
8. Use supplied brush to clean beer faucet parts.
See Image 3.
9. Rinse parts thoroughly.
10. Rinse bucket, pump bottle and hose thoroughly
with clean cool water.
11. Fill pump bottle with clean cool water and pump
through lines until water runs clear. (repeat if
necessary)
12. When crystal clear water comes through, you’re
ready to assemble and reattach faucet and re-tap
the keg.
APPLIANCE SETUP
Loading ...
Loading ...
Loading ...