Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. G | EN10/23/2023Page 30 of 100
PRIOR TO INSTALLATION
DOOR OVERLAY PANEL INSTALLATION
Follow the instructions below to install door overlay
panels. Door overlay panel installation is the
same for solid and glass door units. For custom
panel specifications, please see “Custom Panel
Specifications” starting on page 25.
NOTE: DO NOT INSTALL A SOLID PANEL ON A
GLASS DOOR. THIS MAY CAUSE MOISTURE
TO FORM BEHIND THE PANEL, RESULTING IN
DAMAGE.
REQUIRED TOOLS
Required tools include (but may not be limited to)
the following:
• Surface Protection*
• 3/8" Wrench
• Phillips Bit Driver
• 2+ Clamps ≥ 2" (51 mm)
• 1/8" Drill Bit
• #6 Screws (qty 10)**
• Drill
*Cardboard, moving blanket, foam padding, etc.
** Screw type and length varies by material. All screws must
be 1/2" (13 mm) + Overlay Panel Thickness.
PROCEDURE
1. Carefully lay the door overlay panel on a protected
surface.
2. Remove the kickplate. See fig. 1.
3. Remove the door from the unit. Leave the hinges
installed on the unit. See fig. 2.
NOTE: BE SURE TO SUPPORT THE DOOR
WHILE REMOVING THE HINGE HARDWARE.
DO NOT DISCARD.
4. Remove the gasket. See fig. 3.
5. With a 1/8" drill bit, carefully drill the pre-marked
pilot holes in the door. See fig. 4.
6. Carefully place the door face down on the overlay
panel. Align the door and panel edges. See fig. 5.
7. Clamp the door and panel. See fig. 6
NOTE: IF THE CLAMP JAWS ARE NOT
PADDED, INSERT PADDING BETWEEN THE
CLAMP AND THE OVERLAY TO PROTECT THE
PANEL’S FINISH.
IF DESIRED, INSTALL A HANDLE BEFORE
PROCEEDING TO THE NEXT STEP. FOR BEST
INSTALLATION, FASTEN THE HANDLE WITH
RECESSED SCREWS. SEE FIGS. 7 AND 8.
8. Carefully drill pilot holes into the panel. See fig. 6.
NOTE: TAKE CARE TO NOT DRILL THROUGH
THE FRONT OF THE PANEL.
9. Fasten the overlay panel to the door front. Then,
remove the clamp(s).
10. Install the door gasket.
NOTE: VERIFY THE GASKET IS FULLY
SEATED IN THE GASKET CHANNEL.
11. Install the door assembly. Verify the door closes
correctly and the gasket seals without gaps.
FIG. 1.
Pull the kickplate off the magnets.
Loading ...
Loading ...
Loading ...