Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. G | EN10/23/2023Page 54 of 100
APPLIANCE SETUP
REQUIRED TOOLS
• Phillips Screwdriver
• Adjustable Wrench
KIT CONTENTS
A. CO
2
Tank (Shipped empty. Fill before use)
B. Draft Standard*
C. Draft Standard Screws
D. Draft Standard Handles*
E. CO
2
Pressure Regulator
(single version/double version)
F. Chill Hose**
G. Rubber Washer
H. CO
2
Hoses*
I. Hose Clamps
J. Safety strap
K. Beer Tapper (Sankey, low profile tapper)
*Double draft standard kit shown.
**Located inside the appliance.
DRAFT STANDARD INSTALLATION & HOOK UP
WARNING! – CONTENTS UNDER
PRESSURE. TAKE CARE WHEN
HANDLING FILLED CO₂ TANKS. IF
UNFAMILIAR WITH USING CO₂ TANKS
AND/OR REGULATORS, SEEK INFORMATION
FROM YOUR LOCAL DISTRIBUTOR OR BREWER
REPRESENTATIVE BEFORE PROCEEDING.
PROCEDURE
1. Position the rubber gasket over the mounting holes
in the appliance countertop. See fig. 1.
2. Run the beer line(s) through the hole and into the
appliance. See fig. 2.
3. With the provided hardware, install the draft
standard. See fig. 3.
4. Install the draft standard handle(s). See fig. 4.
5. Remove the draft standard top. See fig. 5.
FIG. 1.
Position the rubber
gasket around the draft tower
hole.
FIG. 2.
Thread the draft standard
lines into the appliance.
FIG. 3.
Secure the draft standard
to the countertop.
FIG. 4.
Screw the handles on.
A
E
B
D K
C
G
I
F
J
H
Loading ...
Loading ...
Loading ...