Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. G | EN10/23/2023Page 32 of 100
PRIOR TO INSTALLATION
DRAWER OVERLAY PANEL INSTALLATION
Follow the instructions below to install drawer overlay
panels. For custom panel specifications, please see
“Custom Panel Specifications” starting on page 25.
NOTE: REMOVE THE DRAWER FRONT AS
DESCRIBED FOR EASY OVERLAY PANEL
INSTALLATION.
REQUIRED TOOLS
Required tools include (but may not be limited to)
the following:
• Surface Protection*
• Phillips Bit Driver
• 1+ Clamp ≥ 2" (51 mm)
• 1/8" Drill Bit
• #6 Screws (qty 8)**
• Drill
*Cardboard, moving blanket, foam padding, etc.
**Screw type and length varies by material. All screws must be 1/2" (13
mm) + Overlay Panel Thickness.
PROCEDURE
1. Carefully lay the drawer overlay panel face down
on a protected surface.
2. With a Phillips bit driver, remove the drawer front
assembly. See fig. 1.
3. Remove the gasket. See fig. 2.
4. With a 1/8" drill bit, carefully drill the pre-marked
pilot holes in the drawer front. See fig. 3.
5. Place the drawer front face down on the overlay
panel. Align the drawer front and panel edges.
See fig. 4.
6. Clamp the drawer front and panel. See fig. 5.
NOTE: IF THE CLAMP JAWS ARE NOT
PADDED, INSERT PADDING BETWEEN THE
CLAMP AND THE OVERLAY TO PROTECT THE
PANEL’S FINISH.
IF DESIRED, INSTALL A HANDLE BEFORE
PROCEEDING TO THE NEXT STEP. FOR BEST
INSTALLATION, FASTEN THE HANDLE WITH
RECESSED SCREWS. SEE FIGS. 6.
7. Carefully drill pilot holes into the panel. See fig. 7.
NOTE: TAKE CARE TO NOT DRILL THROUGH
THE FRONT OF THE PANEL.
8. Fasten the overlay panel to the drawer front. Then,
remove the clamp(s).
9. Install the drawer gasket.
NOTE: VERIFY THE GASKET IS FULLY
SEATED IN THE GASKET CHANNEL.
10. Install the drawer front assembly. Verify the drawer
closes correctly and the gasket seals without gaps.
11. Repeat steps 1-10 for the second drawer.
FIG. 1.
Drawer front screw locations. Other side not shown.
Loading ...
Loading ...
Loading ...