Kenmore 79075715893 gas range

User Manual - Page 19

For 79075715893.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Avoid Service Checklist Beforeyou call for service, review this list It may save you time and expense
The list includes common occurrences that are not the result of defective
workmanship or materials in this appliance
This oven is equipped with a state of the art electronic oven controller, Among
its many features iSa full time oven circuit diagnostics system. The controlle_
constantly monitors its internal circuitry as well as several crucial oven circuits to
insure they are all oPerating correctly. If at any time one of these systems fails,
the Controller will immediately stop operation, beeping and flashing an error
(:ode of F! or F3 in the display window.
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Range is not level.
Poor installation Placeoven rack in center of oven Place a level on the oven
rack Adjust leveling legs at base of range until the rack is level When range is
level, cooktop may appear out of alignment if countertop is not levelo
Weak, unstable floor Be Sure floor is level and can adequately support rahge,
Contact a carpenter to correct sagging or sIoping floor°
Cannot move appliance easily,
Appliance must be accessible for
service.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure
cabinets are square and have sufficient roo_ f0,,_a_ge c!earance, .., •:i i :.!,:_1:_:
Cabinets not square or are built in too tight, Contact a cabinet maker to
correct the problem.
Contact builder or installer to make appliance accessible,
Carpeting interferes with range, Provide sufficient space so range can be lifted
over carpet,
Gas line is hard-plumbed Have a flexible AGA approved metal appliance
connector installed
Oven control beeps and displays
F1 or F3.
Electronic control has detected a fault condition Push CLEAR to clear the
display and stop beeping Reprogram oven, If fault recurs, record fault number,
Push CLEAR and contact an authorized servicer',
5urface burners do not light.
Surface Control knob has not been completely turned to LITE, Push in and turn
the Surface Control knob to LtTE until burner ignites and then turn control
t-nob to desired flame size
Burner ports are clogged, Clean burners, See "To Clean the Contoured Well
Areas, Burner Cap Assembly, Trim Ring (some models), Burner Pan (some
models) and Burner Base" under General Cleaning. With the burner off,
clean ports witl_ a small-gauge wire or needle,
Range p0we[ cord is disconnected from outlet (electric ignition models only),
Be sure cord is securely plugged into the outlet,
Electrical power outage (electric ignition models only) Burners can be fit
manually See Setting Surface Contro!s in this Owner's Guide,
Surface burner flame burns half way Bu_'nerports are clogged With the burner off, clean ports by using a small-
around, gauge wire or needle.
Moisture is present after cleaning Lightly fan the flame and allow burner to
operate until flame is full, Dry the burners thoroughly following instructions in
the General Cleaning section.
Surface burner flame is orange.
Dust particles in main line Allow the burner to operate a few minutes until
flame turns blue
in coastal areas, a slightly orange flame is unavoidable due to salt air,
t9
Loading ...
Loading ...
Loading ...