Kenmore 79075715893 gas range

User Manual - Page 16

For 79075715893.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Unlike the standard gas range, this
cooktop is not removable Do not
attempt to remove or lift the cooktop.
Note: The burner' cap assembly refers
to all parts of the sealed burner' unit
(burner cap, burner pan (some models)i
trim ring (some models), locating tab,
burner base and electrode).
To clean, wipe with a clean, damp cloth and wipe dry,
To Clean the Contoured Well Areas, Burner Cap Assembly,
Trim Ring (some models), Burner Pan (some models) and
Burner Base
The contoured welt areas, burner' cap assembly, trim ring (some models)., burner
pan (some models) and burner base should be routinely cleaned. Keeping the
burnei-ports clean will prevent imprope_ ignition and an uneven flame. See
instructions below.
Burner
Cap
Locating
Tabs
Burner Locating
,_tots
Electrod__
Trim Ring Isome models)
or Burner Pan [some models)
Usecaution when
replacing the burner cap so the
electrode is not damaged, This may
cause a delayed ignition or prevent the
burner from igniting
_Any additions, changes
or conversions required in order for
this appliance to satisfactorily meet the
application needs must be made by a
Sears Salescenter
To Clean the Contoured Well Areas
The contoured well is a recessed area located around each burner unit_ If a spitl
occurs in one of the four welt areas, blot up spill with an absorbent cloth, Rinse
with a clean, damp cloth and wipe dry,
To Remove the Burner'Cap Assembly
The burner cap assembly parts differ per model. Your assembly wilt consist of
one of the following combinations: burner cap and trim ring; burner cap and
burner pan; or burner cap, trim ring and burner pan Remove in the following
order: (1st) burner' cap, (2nd)trim ring and (3rd) burner pan. Do not operate
the burners without the burner cap assembly in place.
To C_leanthe Burner Cap, Burner Pan (some models) and Trim Ring (some
models)
Use a s0aP_filled scouring pad or a mild abrasive cleanser to clean burner caps.
trim rings and burner pans.
To Clean the Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned, Use a
smalFgauge wire or needle to clean small slots or holes,Use care to prevent
damage to the electrode, If a cleaning cloth should catch the electrode, it could
break or damage the electrode. If the electrode is damaged or broken, tlqe
surface burner wilt not light.
For proper flow of gas and ignition of the burner_Do not allow spills, food,
cleaning agents or any other material to enter the gas opening. Gas must
flow freely through the small hole in the brass orifice for the burners to light
properly, tf the orifice gas opening becomes soiled or clogged, use a small-
gauge wire or needle to ctean. ALWAYS keep the burner cap assembly !n place
whenever a surface burner is in use.
To Replace the Burner Cap Assembly
Make sure the burner cap assembly is thoroughly dry before placing back on the
burner,
t, Lower burner pan (some models) into place around the burner base
2. Replace trim ring (some models),
3. Find the locating tabs on the burner cap and place in the locating slots in
the burner base. Make sure each burner cap is properly aligned and level,
4. Turn the burner on to determine if it will light, If the burner does not light
after cleaning, contact an authorized servicer Do not service the sealed
burner yourself,
t5
Loading ...
Loading ...
Loading ...