Loading ...
Loading ...
Loading ...
38
INSTALLATION
WARNING
WARNING
USE AN AUTHORISED PERSON
As stated in the local municipal building codes and other
relevant statutory regulations.
• Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
• Refer to data plate for rating information and circuit
diagram. The data plate is positioned behind the
bottom of the oven door. The circuit diagram is
positioned on the top panel of the appliance.
• For appliances with open cooking surfaces, an all pole
disconnect functional switch should be provided near
the appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1
• Wiring should be protected against mechanical failure.
Refer to AS/NZS3000 clauses 3.3.2.6, 3.9, 3.10
• A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
• To gain access to the mains connection terminals, remove
the rear access cover by unscrewing the 2 screws.
MULTI-PHASE: Where connection is made to a multi-phase
240V supply,
the bridge piece should be removed from between the active
connections.
WARNING
WARNING
This appliance must be properly earthed.
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to secure your
oven into the cupboard. Use just 2 screws for single
cavity ovens and 4 screws for dual cavity. Remove the
bottom door in dual cavity ovens to provide access to the
bottom 2 screwing points (see illustration on page 42).
• For appliances fitted with a flexible supply cord, if the
cord is damaged, it must be replaced by the manufacturer
or its service agent or similarly qualified person in order to
avoid a hazard. The plug must be accessible after installation.
• Where the appliance is built into a cabinet, the cabinet
material must be capable of withstanding 70°C.
Installation into low temperature tolerant cabinetry
(e.g. vinyl coated) may result in deterioration of the
low temperature coating by discolouring or bubbling.
• If the appliance is installed adjacent to vinyl-wrapped
surfaces, use an installation kit available from the vinyl-
wrap supplier.
• Electrolux Home Products cannot accept responsibility
for damage caused by installation into low temperature
tolerant cabinets.
• After installation, test and ensure that the appliance
operates correctly before handing it over to the customer.
To avoid any potential hazard, you must follow our instructions
below when you install your appliance. Failure to install the
appliance correctly could invalidate any warranty or liability
claims and lead to prosecution.
Cabinet construction for your appliance
For the best integration within a kitchen, install this appliance
in a standard 600mm wide cupboard that gives a flush fit
with the surrounding cupboard fronts (figure A).
A recess of 20mm is ideal. It can also be installed using
a proud fit with the surrounding cupboard (figure B).
NOTE: Your appliance must be mounted on a flat surface
for the full width and depth of the product.
WARNING
CAUTION
The infill panel MUST not exceed 100mm in length to ensure
a 16mm gap is maintained.
Flush Fit
16mm
568mm
600mm
20mm
Infill
panel
Cupboard
door
Oven
100mm
max for
Pyro oven
Fig. A
Proud Fit
16mm
568mm
600mm
Infill
panel
Cupboard
door
Oven
100mm
max for
Pyro oven
Fig. B
INSTALLING YOUR APPLIANCE
Loading ...
Loading ...
Loading ...