Loading ...
Loading ...
Loading ...
1818
• The cooktop is supplied with a power cord already tted to the appliance and it is
suitable for a single-phase type electrical connection. (g. 2.4).
• For the two-phase type electrical connection (g. 2.5):
– separate the black and brown wires by removing the metallic terminal;
– remove about 5 mm of the insulation sheathing from the terminal end of the black
and brown wires;
– tightly t a new metallic terminal (2,5 mm) on the terminal end of each wire (black
and brown).
• For the tree-phase type electrical connection (g. 2.6):
– separate the black and brown wires by removing the metallic terminal;
– separate the blue and grey wires by removing the metallic terminal;
– remove about 5 mm of the insulation sheathing from the terminal ends of the black,
brown, blue and grey wires;
– tightly t a new metallic terminal (2,5 mm) on the terminal end of each wire (black,
brown, blue and grey);
– disconnect the grey wire from the terminal block (to access the terminal block see
chapter “CONNECTION OF THE POWER SUPPLY CABLE”) and connect it to the
L3 terminal of the terminal block. Position the U-bolt between the terminals N1 and
N2 of the terminal block and close its cover.
MODELS SUPPLIED WITH POWER CORD 5x2,5 mm
2
ALREADY FITTED TO THE APPLIANCE
ATTENTION!
All the operations/electrical connections must be carried out by a qualied technician.
CAUTION!
Do not pierce or weld the terminal ends of the wires. This is strictly forbidden!
CAUTION!
Do not connect the power cord to the electrical power supply without the metallic terminals
correctly in place.
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualied person in order to avoid a hazard.
Loading ...
Loading ...
Loading ...