Loading ...
Loading ...
Loading ...
1717
CONNECTION OF THE POWER SUPPLY CABLE
Important! This cooktop must be connected to the electricity supply only by an
authorised person.
To connect the feeder cable to the hob it is necessary to carry out the following operations:
• Unscrew the screw “A”
• Unhook the terminal board cover by inserting a screwdriver into the two hooks “B” (g.
2.1). Open completely the terminal block cover.
• Unscrew the screw “C”, then unhook the cable clamp “D” by inserting a screwdriver
into the hook “E”. Remove completely the cable clamp “D” (g. 2.2).
• Connect the phase, neutral and earth wires to terminal board according to the diagrams
in g. 2.3.
• Strain the feeder cable and block it with cable clamp “D” (by hooking hook “E” and
screwing screw “C”).
• Close the cover of the terminal board (check the two hooks “B” are correctly hooked and
screwing screw “A”
).
NOTE: The earth conductor must be left about 3 cm longer than the others.
The operations must be executed by a qualied technician.
220 - 240 V ac
L N PE
380 - 415 V 2N ac
380 - 415 V 3N ac
L1 L2 N PE L1 L3L2 N PE
Fig. 2.3
1
2
1
2
A
B
B
C
E
D
Fig. 2.1 Fig. 2.2
Loading ...
Loading ...
Loading ...