Loading ...
Loading ...
Loading ...
8. Using a wood block and mallet as showm move
rear trunnion to right or left as required to realign
the blade. If necessary, shift front trunnion in
similar manner; but do NOT move front trunnion
unless necessary. Recheck the alignment with
the square, then securely retighten a!l six trunnion
screws.
EDGE OF TRUNNION
CLAW HAMMER
WOOD BLOCK
PLACE BLOCK HERE_ OR HERE
),
EDGE OF
REAR OF SAW CRADLE
BLADE TILT, OR SQUARENESS
OF BLADE TO TABLE
90° (SQUARE) and 45° (BEVEL) STOP COLLARS.
When the bevel pointer is pointing directly to the "0"
mark on the bevel scale, the sawblade should makea
SQUARE cut 90° to the table.
To check for SQUARENESS:
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF' AND REMOVE PLUG FROM POWER
SOURCE OUTLET.
1. Raise blade all the way UP... raise blade guard.
2. TILT blade a few degrees to the LEFT... now dlt
blade back to the RIGHT as far as it will go.
3. Place the square against blade. Make sure square
is not touching the TIP of one of the saw TEETH.
4. Operate the tilt-lock handle (COUNTER-
CLOCKWISE) to loosen the tilt clamp screw.
5. NOTE: Handle is spring loaded for engagement
with screw head - must be pushed inward for
disengagement whenever necessary to obtain a
new grip on screw head.
"ILT LOCK HANDLE
6. Rotate tilt handwheel CLOCKWISE a few turns
to tilt blade, Now rotate handwheel
COUNTERCLOCKWISE until it stops. Blade
should now be square with table and pointer
should point to "0".
39
BEVEL SCALE
TILT HANDWHEEL
TILLPOINTER
Loading ...
Loading ...
Loading ...