Loading ...
Loading ...
Loading ...
5. Reinstall motor pulley the same way it was when
you aligned the belt.
6. Place belt on SAW PULLEY... insert end of belt
through opening in END of guard,
7. Slip belt over motor pulley.
BELT
8. Press guard onto support so that bottom of
guard is approximately 3/4 in. away from belt,
NOTE: To remove guard, lift up on LONG TABS
of clips.., pull guard outward, The clips should
remain on the BELT GUARD SUPPORT.
1
3/4 IN.
PLUGGING IN MOTOR
1. From among the loose parts, find two wire ties.
2. Route motor cord along right side of cabinet and
snap ties in 1/4" hole in side of cabinet. Secure
two cords in wire ties,
3. Plug motor cord into outlet on side of switch box,
WIRE TIES
EXTENSION REMOVED FOR
PICTURE CLARITY
21
Loading ...
Loading ...
Loading ...