Loading ...
Loading ...
Loading ...
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
From among the loose parts find the following
hardware: (Quantity indicated is for 2 extensions)
HARDWARE FOR INSTALLING
EXTENSIONS TO SAW TABLE
Ref.
No. Description Qty,
1 Hex Hdl Screw, 5/16-18 x 1-1/4 ...... 8
2 Flat Washer (Dia: of Hole 11/32) ..... 8
3 External Lockwasher, 5/16 ........... 8
4 He× Nut, 5/16-18 .................... 8
1. |nsert four (4) 5/16-18 x 1-1/4 in. tong screws
through holes in each EXTENSION.
2. Position extension against table so screws
extend through holes in table.
3_ Install flat washer, Iockwashers, and nuts on the
screws... DO NOT TIGHTEN.
4. Line up the rear edge of extension with the rear edge
of the table. Line u0 top sudace of the extension with
the top of the table at the locations indicated by the
"X"s (see illustration). Use a combination square to
line-up these edges. SLIGHTLY TIGHTEN nutswith
a 9/16" wrench.
_'_ JCHECK WITH SQUARE
AT 2 PLACES
MARKED WITH "X"
5. If adjustment is necessary, you should tap the exten-
sion into position using a hammer and a block of
wood. Make sure the rear edge of extension is lined
up withthe rear edge of the table. Thenfirmlytigh
nuts.
6. Repeatthe sameprocedureto installthe otherexten-
sion.
LOCK OF WOOD "
\
11
Loading ...
Loading ...
Loading ...