Loading ...
Loading ...
Loading ...
MOUNTING SWITCH
1. From among loose parts find the following:
2 Hex Head Screws, 5/16-18 x 3/4 in. long
2 Flatwashers (dia. of hole 21/64 in.)
2 External Lockwashers
2 Hex Nuts, 5/16-18
2. Insert two 3/4 inch screws through two flat
washers then through holes in switch.
3. Insert screws through holes eight and ten in front
fence guide bar as illustrated
4. Install two Iockwashers and nuts Tighten nuts,
INSTALLING RiP FENCE GUIDE BARS
1. From among the loose parts find the following
hardware:
2 Hex Head Screws. 5/16-18 x 1-3/4 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
4 External Lockwashers, 5/16 in.
(approx. dia. of hole 5/16 in.)
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16 in.)
2 Spacers. 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
1 Fence Guide Bar Rod
2. Lay guide bars on saw table.
NOTE: The various holes in the bar allows them
to be positioned on this saw and also makes
them adaptable to other models.
3. Insert a 1-3/4 inch long screw through the
THIRD hole IN THE FRONT BAR as illustrated
... Insert another 1-3/4 inch long screwthrough
the SEVENTH hole in bar.
4. Place spacers on screws,
JAM NUT
5116-18
7TH HOLE
t_---_ WASHER
I
HEX HEAD SCREW
5/16-18 x 3/4 IN.
3RD HOLE
LEFT SIDE OF
FRONT GUIDE BAR
(GUIDE BAR IS TO BE
TURNED END FOR ENE
AFTER SCREWS ARE
INSTALLED)
HEX HEAD
SCREW
5/16-18 x 1-3/4 IN
5. Turn front bar end for end and insert bolts
through holes in middle and on right sides of
front of saw table as illustrated . . . install
Iockwashers and nuts. DON'T SCREW NUTS
ON ALL THE WAY, just get them started on the
screws.
4TH OR 5TH 2ND HOLE
_k"_ SELF-THR EAD|NG NUT HOLE
6. Inse[t 1 in. long screws in SECOND and _ - /"
FOURTH or FI FTH holes of rear bar and attach
to table the same way as front bar.
7. Insert ends of FEKICE GUIDE BAR ROD F
through holes in bars as illustrated. BAR ROD
NOTE: The ends of the ROD are not threaded ...
the SELl: THREADING NUTS wil! cut threads
on the rod as they are screwed on. Just start nuts c
onto ends of rod.
]2
Loading ...
Loading ...
Loading ...