Craftsman 113298720 10" table saw

Owners manual - Page 24

For 113298720.

PDF File Manual, 52 pages, Read Online | Download pdf file

113298720 photo
Loading ...
Loading ...
Loading ...
NEVEROPERATETHE SAW WITHOUT THE
PROPERINSERTIN PLACE.USEOFTHE SAW
BLADEINSERTWHENSAWING. . . USE THE
COMBINATrONDADOMOLDINGINSERTWHEN
DADOINGORMOLDING.
9
REMOVING AND iNSTALLING SAWBLADE.
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE REMOV-
ING OR INSTALLING SAWBLADE.
A. Raise Blade Guard... remove insert.
B. To REMOVE blade, place a block of wood
against front of blade... PULL arbor wrench
toward you to LOOSEN arbor nut.
ARBOR
WRENCH
/
!
WOOD BLOCK
ARBOR NUT
BLADE GUARD NOT SHOWN
FOR PICTURE CLARITY
C. To TIGHTEN arbor nut, place a block of wood
against rear of blade... PUSH wrench away
from you.
When installing the blade.., make sure the teeth
are pointing toward the front of the saw.. and
that the blade and collars are clean, and free
from any burrs.
The HOLLOW side of the collar must be against
the blade.
Always tighten the arbor nut securely.
NOTE: When using the Dado or Mold ing Head, it
is not necessary to install the loose collar.
To replace insert.
Place insert into insert opening in table and push
towrd rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten
screw.
Do not tighten screw to the point where it will
deflect the insert.
BLADE GUARD NOT SHOWN
PICTURE CLARITY
NUT
LOOSE
COLLAR
ARBOR
TEETH POINTING TO _ _T" -_;-
FRONT OF SAW _'_ .
10 EXACT-I-CUT
The "yellow" plastic disc imbedded in the table
in front of the sawblade, is provided for marking
the location of the "sawcut" on the workpiece.
A. Check disc.., if it is above table surface,
place a piece of hardwood on top of it and tap
it down.
B. With blade90 ° (squaretotable} cutoff apiece
of wood.
C. Pull miter gauge back until wood is over disc.
Using very sharp pencil, mark a line on disc.
D. With miter gauge in right hand groove, follow
same procedure and mark another line on
disc.
..... ,i 71 t
E. These lines ndcate the path of the cu
(kerf) made by the sawblade.
F. When cutting the workpiece, line up mark on
workpiece with line on disc.
8LADEGUARDNOTS.OW.
24
Loading ...
Loading ...
Loading ...