Loading ...
Loading ...
Loading ...
16.Make two folds n a small piece (6 x 6 in,) of
ordinary NEWSPAPER making three thicknesses.
The folded paper will be used as a "spacing
gauge".
/
I
17. Place RIP FENCE on table...
CAREFULLY move it against blade so that it is
paralletto the blade and just TOUCHES tips of saw
teeth.., tighten RIP FENCE LOCK LEVER.
18. Insert folded paper between SPREADER and
FENCE,
19. Using a 7/16" wrench, loosen the 1/4-20 hex head
screws so the spreader can slide sideways.
20. Hold spreader flat against fence.., tighten screws
using 7/16" wrench.
21. To remove BLADE GUARD and SPREADER, loosen
THUMBSCREW . DO NOT LOOSEN OTHER
SCREWS. This lets you remove and replace the
guard without disturbing the spreader alignment.
7/16 IN, WRENCH
\
FOLDEDPAPER
MOUNTING THE MOTOR
CHECK MOTOR ROTATION
1. The motor must rotate CLOCKWISE when re-
viewed from the 5/8 in. shaft,
2. MAKE SURE"KEY" IS REMOVED FROM SHAFT
3. Place the motor on your workbench or on the
floor.
4. Plug the cord into a properly grounded outlet
(See "Motor Specifications and Electrical Re-
quirements" Section). Notice the rotation of the
shaft. If it is not turning CLOCKWISE, REMOVE
the plug from the outlet, and change the rotation
of the motor according to the instructions
furnished with the motor,
KEY
/
J
5/8 IN. _ION
DIA, SHAFT
OUTLET WHEN CHANGING MOTOR ROTATION.
18
Loading ...
Loading ...
Loading ...