Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR SAW
9 SAWBLADE
8 TABLE INSERT
10 EXACT-I-CUT
6 MITER GAUGE
RIP FENC_
LOCK HANDLE _ _,_
4 TILT LOCK HANDLE -\_.C
(UNDERNEATH TABLE)
1
2 ELEVATION HANDWHEEL
\
"_ ON-OFF SWITCH
7 BLADE GUARD
ANTIKICKBACK
PAWLS
\
3 TILT HANDWHEEL
ON-OFF SWITCH
CAUTION: Before turning switch on, make surethe
blade guard is correctly installed and operating
property.
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO HELP PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS
USE BY CHILDREN AND OTHERS.
A. TO turn saw ON... stand to either side of the
blade never in line with it... insert finger
under switch lever and pull END of lever out.
After turning switch ON, always allow the
blade to come up to full speed before cutting.
Do not cycle the motor switch on and off
rapidly, as this may cause the sawblacle to
loosen. In the event this should ever occur,
allow the sawblade to come to a complete
stop and retighten the arbor nut normally, not
excessively. Never leave the saw while the
power is "ON'!.
B. TO turn saw OFF.. PUSH lever in. Never
leave the saw until the cutting tool has come
to a complete stop.
C. TO lock switch in OFF position.., hold switch
IN with one hand ... REMOVE key with other
hand.
RIP FENCE
HOLES FOR
ATTACHING FACING
KEY
(YELLOW PLASTIC)
= ",, ;o,....
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW TABLE
SURFACE. (IF BLADE IS TILTED, RETURN IT TO
VERTICAL (90 ° ) POSITION), ALWAYS LOCK THE
SWITCH "OFF". WHEN SAW iS NOT IN USE...
REMOVE KEY AND KEEP IT iN A SAFE PLACE... OFF... LOCK IT AND REMOVE THE KEY. THIS
ALSO... IN THE EVENT OF A POWER FAILURE WiLL PREVENT THE SAW FROM STARTING UP
(ALL OF YOUR LIGHTS GO OUT) TURN SWITCH AGAIN WHEN THE POWER COMES BACK ON.
22
Loading ...
Loading ...
Loading ...