Loading ...
Loading ...
Loading ...
Miter-angle indicator adjustment (if necessary)
1. Unplug the saw.
,_, WARNING: Failure to unplug your
saw could result in accidental starting
causing serious injury.
2. Place the miter table at the zero
position, making sure the miter-lock
knob is securely tightened.
3. Loosen the miter-angle indicator screw
and adjust the indicator to the "0" mark
on the miter scale (see Fig. 27).
4. Tighten the miter-angle indicator screw.
Bevel adjustment
1. Unplug the saw.
_lk WARNING: Failure to unplug your
saw could result in accidental starting
causing serious injury.
2. Loosen the bevel lock (Fig. 28) by
turning it counter-clockwise
3. Tilt the saw head to the desired angle
as indicated on the bevel scale. The
blade can be positioned at any angle,
from a 90° straight cut (0° on the
scale) to a 46° left bevel.
4. Tighten the bevel lock to secure the
saw head.
Miter scale Indicator screw
Bevel igle indicator
THROAT PLATE SLOT (Fig. 29)
The throat plate was cut (slotted) at the
factory for a 0° bevel/miter cut.
The first cut you will make with the saw
will be to increase the slot in the throat
plate by setting the bevel scale to 46° and
making a cut. See the Operation section
of this manual for cutting instructions,
_, WARNING: Read all operating instructions and warnings before performing
this cut to avoid injury.
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory, and under normal
circumstances do not require readjustment.
Saw-Arm Travel Pivot Adjustment:
Your saw arm should rise (travel) completely to the up position without assistance.
21228 Manual Revised 08-0307 Page 26
Loading ...
Loading ...
Loading ...