Loading ...
Loading ...
Loading ...
3. Lower the saw arm and lock it into the DOWN position.
4. Using a square, place the heel of the square against the blade, and the rule
of the square against the fence.
NOTE: Be sure to rest the square against the body of the blade and not against
the teeth of the blade.
5. If the blade is not 90 ° to the fence, loosen the four fence-locking nuts. Adjust
the fence 90° to the blade. When blade is 90 ° square to fence, re-tighten the
two fence-locking nuts.
\
\
Fig. 22
SQUARING THE BLADE TO THE MITER TABLE: 0° Bevel, 0° Miter
(Fig. 23 and Fig. 24)
,_ WARNING: Failure to unplug your
saw could result in accidental starting
causing serious injury.
1. Unplug the saw.
2. Set the bevel and miter angle scales
to 0° and lock them in place.
3. Lower the saw arm and lock it into
the DOWN position.
4. Place a square on the miter table with
the rule against the table and heel of
the square against the saw blade.
NOTE: Be sure to rest the square against
the body of the blade and not against the
teeth of the blade.
5.
6.
Fig. 23 _
,/
........'!
de 90° Square to MiterTable
Fig. 24a \
If the blade is not 90 ° square with
the miter table, perform steps 6
and 7, below.
Loosen the bevel-lock knob, turn it
counterclockwise, square the blade
to the table, and pull out the bevel
0°locking bolt; you may need to move the saw arm left or right by hand. (Fig. 24)
21228 Manual Revised 08-0307 Page 24
Loading ...
Loading ...
Loading ...