Loading ...
Loading ...
Loading ...
SETTING UP THE MITER SAW
Installing the dust bag (see Fig. 17)
Place the bag's neck opening around the
dust-extraction port.
Emptying the dust bag The dust bag is
equipped with a zipper to make it easy
to empty the bag. Remove the dust bag
from the dust extraction port, hold it over
a suitable receptacle, and unzip the bag
to empty its contents.
Use with a shop vacuum An adapter
(adapter sold separately) permits a shop
vacuum to be attached to the dust-
extraction port.
Releasing and locking the saw head
1. Gently press and hold down the saw
head. Pull out the Saw-head locking
pin to release the saw head. The saw
head should freely move up and down
(see Fig. 18).
2. Place the saw head at the lowest
position. Insert the Saw-head
locking pin to lock the saw head for
transporting and storage.
Removing the blade (see Fig. 19)
_, WARNING: To reduce the risk of
injury, always unplug the tool before
removing and installing a blade.
1. Unplug the saw.
2. Release and raise the saw head.
3.
4.
5.
6.
7.
Remove the upper screw on the
arbor-bolt guard (Fig. 1, item 5) by
turning it counter-clockwise with
a screwdriver.
Fig. 17
Dust bag
ust extraction
Fig. 18
Fig. 19
Outer flange
Arbor
Arbor bolt
Inner flange Blade
Lift and hold up the lower blade guard (Fig, 1, item 17) and rotate the arbor-
bolt guard to expose the threaded arbor bolt.
Press and hold the arbor-lock button (Fig. 1, item 18) then rotate the blade
with the blade wrench (included) while depressing the arbor-lock button until
the blade is locked in position.
Use the wrench to turn the arbor bolt clockwise and remove the arbor bolt.
21228 Manual Revised 08-0307
Remove the outer flange and the blade. Wipe the flanges and the arbor to
remove any dust and debris.
Page 22
Loading ...
Loading ...
Loading ...