Loading ...
Loading ...
Loading ...
(429,1)
北米Model "A9020BE-B" EDITED: 2022/ 5/ 16
and insert it again.
3. Be sure the level gauge is correctly
inserted until it stops.
1) Full level
2) Low level
3) Approximately 1.1 US qt (1.0 liters, 0.9
Imp qt) from low level to full level
4. Pull out the oil level gauge again.
5. Check the oil levels on both sides of the
level gauge. The engine oil level must be
judged by the lowest of the two levels. If
the oil level is below the low level mark,
add oil so that the full level is reached.
CAUTION
. Be careful not to touch the engine
oil filter when removing the oil
filler cap. Doing so may result in a
burn, a pinched finger, or may
cause some other injury.
. Use only engine oil with the
recommended grade and vis-
cosity.
. Be careful not to spill engine oil
when adding it. If oil touches the
exhaust pipe, it may cause a bad
smell, smoke, and/or a fire. If
engine oil gets on the exhaust
pipe, be sure to wipe it off.
To add engine oil, remove the engine oil
filler cap and slowly pour engine oil
through the filler neck. After pouring oil
into the engine, you must use the level
gauge to confirm that the oil level is
correct.
NOTE
. To prevent overfilling the engine oil,
do not add any additional oil above the
full level when the engine is cold.
. After adding or changing the engine
oil, warm up the engine and stop it on a
level surface, then start the engine after
a lapse of 1 minute or more. Confirm
that the warning light has turned off
after the engine has started. Refer to
“Engine Low Oil Level Warning Indica-
tor” �P158.
& Changing the Oil and Oil Filter
s11ae02
Change the oil and oil filter according to
the maintenance schedule in the “War-
ranty and Maintenance Booklet”.
NOTE
. Changing the engine oil and oil filter
should be performed by a well-trained
expert. Contact your SUBARU dealer
for changing the engine oil and oil filter.
Fully trained mechanics are on standby
at a SUBARU dealer to utilize the
special tools, spare parts and recom-
mended oil for this work, and also, used
oils are properly disposed of.
. If performing oil replacement your-
self, observe the local regulations and
dispose of waste oil properly.
& Recommended Grade and
Viscosity
s11ae03
CAUTION
Use only engine oil with the recom-
mended grade and viscosity.
Refer to “Engine Oil” �P464.
NOTE
Engine oil viscosity (thickness) affects
fuel economy. Oils of lower viscosity
– CONTINUED –
Engine Oil
427
11
Maintenance and Service
Loading ...
Loading ...
Loading ...