Loading ...
Loading ...
Loading ...
21
W415-1361 / 11.28.14
EN
A. Remove the 7" (178mm) diameter cap from the top of the appliance and
re-secure it over the 7" (178mm) collar located at the rear of the appliance.
Press fi rmly on the cap while securing to ensure an airtight seal. Do not
damage the gasket.
B. Remove the plate covering the 4" (102mm) diameter fl ue opening (seen
inside the top of the 7" (178mm) diameter collar) and discard. Try not to
disturb the retaining ring or the gasket beneath. Re-secure the ring and
gasket using the screws removed from the plate.
C. From inside the fi rebox, insert the 4" (102mm) fl ue pipe / gasket assembly
through the heat shield and out through the retaining ring. Secure the assembly to the rear and top
of the appliance using 4 #8 x ¾" Hex Head Wildrill screws supplied. Do not overtighten. The gasket
needs only to be snug against the fi rebox.
!
WARNING
FAILURE TO INSTALL THE CAP WILL CAUSE THE APPLIANCE TO FUNCTION IMPROPERLY AND
CAN CAUSE INJURY OR PROPERTY DAMAGE.
4.0 PRE-INSTALLATION PREPARATION
4.1 DOOR OPERATION
For optimum performance, it is recommended that all horizontal runs have a 1" (25mm) rise per foot.
Release the top and bottom door latches, located at the right side of the door.
4.2 REAR EXIT
From inside the fi rebox, insert the 4" (102mm) fl ue pipe / gasket assembly (provided)
through the rear of the fi rebox. Secure the gasket assembly to the rear and top of the
appliance using 4 #8 x ¾ inch Hex Head Wildrill screws supplied.
Do not overtighten. The gasket needs only to be snug against the fi rebox.
Before attaching elbows to the collars on the back of the appliance, 1½" (38mm) will
need to be trimmed off the 4" (102mm) collar.
!
WARNING
FAILURE TO INSTALL THE CAP WILL CAUSE THE APPLIANCE TO FUNCTION IMPROPERLY AND
CAN CAUSE INJURY OR PROPERTY DAMAGE.
4.3 TOP VENT
Loading ...
Loading ...
Loading ...